Savage Drawing and Deep Drawing presses are available in four-post guided platen, gib guided and straight side housing type frames. Fully hydraulic powered cushions, knockouts, ejectors and blankholders are available in a variety of configurations to meet your tool requirements. Savage Double Action and Triple Action Deep Drawing Presses are available with different slide constructions to accomodate your specific tools. Drawing Press Designs are available with:

• Conventional slide (punch) above the blankholder
• Punch within the blankholder consisting of an inner punch slide with outer downacting blankholder and lower cushion.
• Upacting lower punch with a downacting blankholder (and/or cushion).

Electro-hydraulic controls are available to make any or all of the press functions programmable. The Savage setup controller with touchscreen operator interface is user friendly. At the touch of a finger, the operator can change press set-ups from those stored in memory, making set-up faster and consistently repeatable from job to job. Simply enter a job number assigned to a die and the press is ready to run. Optimum pre-established setpoints are automatically entered for slide and cushion tonnage, speeds, positions and dwell time values.

(2) 250 Ton 60" x 48" Presses shown

4 Post Drawing Press

Conventional draw presses with down acting punch and lower cushion. Fully programmable tonnage, speed and position with program storage, quick die change systems and cushion. Also available in straight side construction.

More information about this product is available here in the form of a PDF document.

If you do not have a PDF reader, you can download one for free here:

Savage C-Frame Guided Platen Metal Drawing Press

Downacting punch with lower cushion for forming / drawing sheetmetal. Fully programmable with program storage, quick die change systems and cushion.

200 Ton Triple Action Four Post Press

Savage Triple Action Deep Draw Press

Four post press with conventional slide above the blankholder type construction. Arrangement utilizes two slides operating on the same guide rods. The blankholder has a through hole in the center to allow the upper punch die to pass through and contact the work. Lower hydraulic cushion to maximize the draw depth without wrinkling.

More information about this product is available here in the form of a PDF document.

If you do not have a PDF reader, you can download one for free here:

50 Ton shown

C-Frame Guided Platen Drawing Press with Cushion

Press shown includes eight bushing guide system, swing-out side guards and light curtains for die changeover. A fully hydraulic cushion, removeable t-slotted bolsters, leveling pads, die safety block and high speed hydraulics.

More information about this product is available here in the form of a PDF document.

If you do not have a PDF reader, you can download one for free here:

4 Post Deep Drawing Press

This high speed, low tonnage press is used for drawing stainless steel cannisters. A fully guided hydraulic cushion prevents wrinkling of sheet.